Driven.Media Reverse Light Overlay for the GR86 / BRZ 2022+

Unfortunately, Subaru and Toyota decided to use practically the same design for the reverse light on the 2nd generation. It’s a bit of a dated design for a modern looking car. With the Driven.Media Reverse Light Overlay, it truly blends into the bumper giving the rear end of the car a cohesive appearance while still remaining functional as you can see in the photo with the reverse lights on. Driven.Media designed and cut these overlays in-house using high-quality vinyl to ensure proper fit and finish. 

Install Instructions

• Installation requires the removal of the plastic cover around the reverse light.
• Remove the 3 pop clips on the underside of the bumper and then you’ll be able to pull the cover off.
• Prior to applying the overlay, make sure the surface is thoroughly cleaned and dry.
• arefully peel the overlay off of the backing and use the outline of the inner lens of the reverse light to line up the overlay. (Since the bumper covers a portion of the light, this doesn’t need to be exact as we’ve designed the overlay to give you some leeway.)
• Once you have successfully positioned the overlay where you want it, use a vinyl squeegee or microfiber to remove any air bubbles.
• It is recommended to allow at least 48hrs before washing the car to allow for the adhesive to cure and avoid directly spraying them with a pressure washer.
• The temperature needs to be a minimum of 65°F for proper application.